The vector concept is illustrated in Figure 10.11 below:Your choices as a network administrator are to use dynamic routing protocols on your network or static routing, which is where you manually add each route for your network onto each router.3.5Compare and contrast static routing and dynamic routingAdded a new switch and all VTP information has changed?04:23:31: %PORT_SECURITY-2-PSECURE_VIOLATION: Security violation occurred, caused by MAC address 3a0 on port Gi0/2.Access Mode VLAN: 20 (VLAN020) Trunking Native Mode VLAN: 1 (default) Administrative Native VLAN tagging: enabled Voice VLAN: 10 (VLAN010)System Capabilities: B,REnabled Capabilities: R Management Addresses: IP: 10.1.1.9 Stratum numberSuccess rate is 100 percent (5/5), round-trip min/avg/max = 18/28/32 msAs well as filtering traffic, ACLs can be used to reference NAT pools, to filter your debugging commands, boson ccnp 350-401, and with route maps (this is outside of the CCNA syllabus requirements). It is simply a quantity (number) in a particular direction or course. This native VLAN must also be configured on the respective router subinterface using the encapsulation dot1Q native subinterface configuration command.A one-dimensional vector is a directed quantity. If the trunk is configured as an 802.1Q trunk, a native VLAN must be defined if a VLAN other than the default will be used as the native VLAN. It’s operating as an access port and DTP is turned on due to the Negotiation of Trunking: On output.14.3below:Troubleshooting DNS IssuesN2 - OSPF NSSA external type 2, E1 - OSPF external type 1, E2 - OSPF external type 2, E – EGP, i - IS-IS,2.Add default gateways on the hosts to reach the router IPs.trunk link because routers don’t support DTP.
Boson test engine manual#
The settings tell you that the port has dynamically become an access port (as opposed to a manual configuration).
0 kommentar(er)
